HPR4382: Understanding Antenna Gain and the Decibel scale

Hacker Public Radio

Content provided by HPR Volunteer and Hacker Public Radio. All podcast content including episodes, graphics, and podcast descriptions are uploaded and provided directly by HPR Volunteer and Hacker Public Radio or their podcast platform partner. If you believe someone is using your copyrighted work without your permission, you can follow the process outlined here https://podcastplayer.com/legal.

7M ago

MP3•Episode home

Power Measurement and Antenna Gain HPR show by Paulj, May 2025. 1.0 Power expressed in dB (also written as dBW) Power PdB = 10 . log10P Where P is the power expressed in Watts. 2.0 Power expressed in dBm Power PdBm = 10 . log10P Where P is the power expressed in milliwatts. 1W = 1000mW Power PdBm = 10 . log101000mW Power PdBm = 30 dBm so: 0 dB = 30 dBm 3.0 Power expressed relative to an isotropic antenna - dBi An Isotropic antenna is an theoretical ideal antenna which radiates equally in all directions. Imagine the antenna is at the centre of a sphere, the signal strength at the surface of the sphere is equal at all points. The gain of an isotropic antenna is defined as 1, meaning: 10 dB = 10 dBi 4.0 Power expressed relative to a half wave dipole antenna - dBd The simplest practical antenna is a half wave dipole antenna, where each of the two legs is a quarter wave length long. The feed is at the centre, and the two legs are generally horizontal, and aligned away from the feed point 180 degrees apart. The dipole antenna exhibits gain perpendicular to the legs. The maximum gain is 1.64 times the isotropic antenna - a gain of approximately 2.15dBi. The gain off the ends of the dipole is much lower - the total power radiated by the antenna can not exceed the power being input, so if there is more radiation (gain) in one direction, there must be a corresponding reduction in a different direction. So: 2.15 dBi = 0 dBd 5.0 Effective Radiated Power - ERP and EIRP ERP and EIRP are both used to indicate the power achieved using an antenna.ERP compares the antenna performance with a dipole, and EIRP compares the performance with an isotropic antenna. So, the ERP is the power which would need to be fed into a dipole antenna, to get the same effect in the direction your antenna is pointing. EIRP is the power required for an isotropic antenna to gain equivalence. Practical example: My KX3 can transmit 15W. using the formula above, this is 11.77 dB. If I attach a Yagi-Uda antenna with a gain of 10dB, the ERP is 21.77 dB. Using the formula above, from this number you can calculate that this is the equivalent of 150.3142 Watts ERP. To understand the EIRP, we need to add 2.15 to the 21.77 dB value, giving 23.92 dB EIRP. Again, converting to actual power gives 246.515 Watts EIRP. If you are comparing antennas, make sure the same units are being used in all cases (either EIRP or ERP) - some sellers will use EIRP, because the values are higher! Check your licence conditions. Power output limits are often at the antenna, and don't include antenna gain. You can set your transmitter to output sufficient power to overcome any feed line losses, and present up to the power permitted to the antenna. A good antenna can then be used to get the transmitted power out and across the world. For feedline loses, the value is given in dB per 10 metres. For example, RG58 is 2dB / 10 metres (at

4549 episodes

#Tech #Community Radio #Tech Interviews #Linux #Open #Software Freedom #Tech News #HPR Volunteer #Hacker Public Radio #Podcasting Education #Hobbies